お知らせ • Sep 12
Beauce Gold Fields Announces Results of Placer Gold Studies Related to Its Ditton Gold Property, Located in Chartierville, Quebec
Beauce Gold Fields announced the results of placer gold studies related to its Ditton Gold property, located in Chartierville, Quebec, near the US-New Hampshire border. Study Highlights: High-grade heavy black concentrates containing placer gold grains and nuggets. Gold grains recovered weighing a total of 1.07 grams including a 5mm gold nugget. Placer gold grains contain an average of 90% gold (Au) and 10% silver (Ag). Indications of significant amounts of gold encapsulated in pyrite Results warrant further evaluation for potential placer gold production. Indications the placer gold originated from two types of mineralized hard rock deposits. The study builds on the Company's 2023 bulk sampling tests conducted at specific locations on the Ditton property, including the SB-100, SB-101, and SB-102 sites within the Ditton quarry. The bulk sampling targeted quaternary and tertiary glacial till to recover placer gold grains and heavy mineral concentrates for analysis and to evaluate in-field gravity recovery methods. Bulk Sampling Details: SB-100: A 50-ton bulk sample was excavated from unconsolidated quaternary-type glacial till from a ground-level trench located approximately 300 meters north of the operating Ditton (Blais) quarry. SB-101 and SB-102: These two 50-ton bulk samples, consisting of tertiary (oxidized and compact gravel) material, were excavated from trenches in the Ditton quarry floor, with trenches reaching depths of up to 6 meters.
The processing of these samples was conducted on-site by Explolab, of Val d'Or, Quebec. A mobile placer plant equipped with a trommel and a 10-foot by 12-inch sluice box was used to process lower, variable volumes of the 50 tons sample piles, reducing them to concentrates for further analysis. These concentrates were subjected to gravimetric concentration, separating the heavy minerals for laboratory analysis. Gold grains large enough for manipulation were weighed and measured, and additional heavy black mineral concentrates were further concentrated using a Wilfley Table. The final heavy black mineral concentrates and the gold grains were combined to make samples which averaged 394 grams each. They were sent to MSALABS in Val d'Or for Photonassay analysis. This non-destructive technique allows for the detection of non-visible gold and for coarse gold, ensuring that the sample remains intact for potential further testing and confirmation. SB-100: A weighted average of 154.98 grams of gold per ton of concentrate was obtained, producing 35.28 kilograms of concentrate. Significant findings included a 5mm gold nugget, with eight gold grains recovered weighing a total of 0.63 grams. Notably, significant quantities of pyrite were also observed. SB-101: A weighted average of 38.47 grams of gold per ton of concentrate was obtained, resulting in 31.08 kilograms of concentrate. The sample contained a notable gold nugget weighing 0.44 grams. SB-102: This sample resulted in 10.70 kilograms of concentrate, with a weighted average of 59.22 grams of gold per ton of concentrate. Association of placer gold and pyrite A control test was conducted on a 77-kilogram sample, taken randomly from the 50-ton SB-100 bulk sample pile. After sieving at 10 mesh, two samples were obtained: one weighing 31 kilograms (greater than 10 mesh) and another weighing 46 kilograms (less than 10 mesh). The latter was concentrated to produce 1,028 grams of mineral concentrate, which exhibited no visible gold but showed traces of pyrite (FeS). Photon assay analysis yielded 17.67 grams of gold per ton of concentrate, with an implied placer gold grade of 0.43 g/m³. A previous 28-litre sample collected by suction dredge at the SB-100 site resulted in 0.45 g/m³ in gold grains and 1.71 g/m³ of non-visible gold. The results, showing that gold was derived from both coarse visible gold and non-visible forms, suggest that part of the gold may be encapsulated within the pyrite matrix. Future tests and sample programs will have to take pyrite recuperation into consideration. Understanding the association of gold with pyrite can lead to more effective extraction methods. Placer gold grain geochemistry: The Company commissioned GEOX Inc. to characterize the chemistry of 31 gold grains and 2 grains of pyrite that were previously recovered from six sample locations of the quarry located on the Ditton property. The gold grains were mounted on a polished thin section by VanPétro /Vancouver Petrographics Ltd. and analyzed using a scanning electron microscope (SEM) and Energy Dispersive X-ray (EDS) at IOS Services Géoscientifiques Inc. The analyses revealed that the gold grains averaged 89.92% gold (Au) and 9.95% silver (Ag), with a fineness ranging between 850 and to greater than 950. The study identified three distinct groups of gold grain samples based on their fineness and chemical composition: Silver-poor gold grains with fineness greater than 950 (samples SB-05 and 13-3-1). Gold grains with homogeneous fineness ranging from 850 to 860 (samples SB-100 and SB-102). Gold grains with variable fineness, ranging from Ag-poor gold grains to electrum, which may contain copper and tellurium (samples SB-101 and SB-10, and an electrum grain in sample SB-102). The gold grains in samples SB-05, 13-3-1, SB-100, and SB-102 may originate from orogenic gold-type mineralized zones, possibly including pyrite with trace arsenic content. In contrast, the gold and electrum grains in samples SB-101 and SB-10 may derive from mineralizations richer in silver, copper, and tellurium, potentially indicating a magmatic-hydrothermal origin. The placer gold studies, along with the Company's 2022 overburden sonic drilling results, support continued exploration to assess whether the property holds a substantial placer gold deposit. These findings also encourage the Company to search for the source of the placers, which could
potentially lead to future bedrock lode gold discoveries.